menu

News

Half Battenburg Livery Kit

Written On By Katie

Front Livery

The word POLICE shall be positioned back to front on the bonnet of the vehcle using Reflexite VC312 Daybright Blue. The front pillar of the cab will be highlighted using Reflexite VC312 Daybright Silver/White. The daybright material should be cut leaving a 6mm gap from the edges of the pillar.

Side Livery

The side livery will consist of one row of alternating colour panels of Reflexite VC312 Fluoresent Lime or Fluoresent Yellow and Reflexite VC312 Daybright Blue.

The pattern should start in the centre of the vehicle with a panel using Reflexite VC312 Daybright Blue.

Reflexite VC312 Daybright Fluoresent Lime or Fluoresent Yellow panels should be fitted to either side of this panel.

The pattern should then be extended horizontally with alternating colours to the front and rear of the vehicle ending with Fluoresent Yellow panels.

The word POLICE shall be positioned below the above pattern to fit between the front and rear wheel arch using Reflexite VC312 Daybright blue. The lettering shall be spaced to ensure the letters do not overlap the door edges.

PLEASE NOTE: A block of Reflexite VC312 Daybright Silver/White can be applied between the front and rear wheel arches before applying the POLICE lettering.

The panels should be cut leaving a 6mm gap around the edges of the doors, sills, wheel archs, bumpers, door handles, fuel filler cap and windows.

The door edges and centre pillar, the rear pillar and roof line should be outlined using Reflexite VC312 Daybright Fluoresent Lime or Fluoresent Yellow.

The Daybright material needs to be cut leaving a 6mm gap at the edges.

The horizontal length of the panels should be 600mm or greater and of equal length for all panels, except for the front most and rear most panels.

The vertical height of the panels should be 300mm or greater and of equal height.

Rear livery

The rear of the vehicle should have a chevron pattern using Reflexite VC312 Daybright Fluoresent Lime or Fluoresent Yellow and Reflexite VC312 Fluoresent Orange.

PLEASE NOTE: Reflexite VC312 Daybright Red can be used to replace the Fluoresent Orange, however the PSDB recommend the Fluoresent Orange.

The centre point of the rear window should be located and a line drawn from this point to the corners of the rear of the vehicle.

A strip of Reflexite VC312 Daybright Fluoresent Orange should be applied, below and to the edge of the lines starting at the window level.

Reflexite VC312 Daybright Fluoresent Lime or Fluoresent Yellow strips are laid above and below the Fluoresent Orange strip.

As much of the rear as possible should be filled with additional strips, in an altering patteren.
The rear window and roof line should be outlined with Reflexite VC312 Daybright Fluoresent Lime or Fluoresent Yellow.

The strips of Daybright material used for the chevrons should be a minimum width of 150mm.

The Daybright materials used for the rear window and roof line should be a minimum width of 25mm.

The Daybright material should be cut to leave a 6mm gap at the edges of the boot, lights and any other fittings.

The word POLICE shall be positioned in either the rear window or the rear bumber using Reflexite VC312 Daybright Red.

PLEASE NOTE: The Daybright material conforms to shallowcurved surfaces, however the material should be cut to allow for complex curves.

Written in VC312
Top