menu

News

Full Battenburg livery Kit

Written On By Katie

Font Livery
The word POLICE shall be posistioned back to front on the bonnet of the vehicle using Reflexite VC312 Daybright Blue. The front pillar of the cab will be highlighted using Reflexite VC312 Daybright Silver/White. The Daybright material should be cut leaving a 6mm gap from the edges of the pillar.

Side livery

The side livery will consist of two rows of altering colour panels of Reflexite VC312 Daybright Fluorescent Yellow and Reflexite VC312 Daybright Blue.

The pattern should start in the centre of the vehicle with a panle using Reflexite VC312 Blue.

VC312 Daybright Flouresent Yellow panels should be fitted to either side of this pannel.

The panel should be extended horizontally with alternating colours to the front and rear of the vehicle ending with fluorescent yellow panels.

The patteren should then extend horizontally with altering colours to the front and rear of the vehicle.

The lowest row may be of any height to fill the side of the vehicle. The panels should be cut leaving a 6mm gap araound the edges of the doors, sills, wheel arches, bumpers. Door handles, fuel filler cap and windows.

The door edges and centre pillar and roof line should be outlined using Reflexite VC312 Daybright Fluorescent Yellow.

The Daybright material needs to be cut leaving a 6mm gap at the edges.

The horizontal length of the panels should be 600mm or greater and of equal length for all panels, exept for the front most and rear most panels.

The vertical height of the panels should be 300mm or greater and of equal height, except for the lowest row.

Rear Livery

The rear of the vehcle should have a chevron pattern using Reflexite VC312 Daybright Fluoresent Yellow and Reflexite VC312 Daybright Fluoresent Orange.

PLEASE NOTE Reflexite VC312 Daybright Red can be used to replace the Fluoresent Orange, however the PSDB recommend the Fluorescent Orange.

The centre point of the rear window should be located and a line drawn from this point to the corners of the rear of the vehcle. A strip of Reflexite VC312 Daybright Fluoresent Orange should be applied, below and to the edge of the line starting at the window level. Reflexite VC312 Daybright Fluoresent Yellow strips are laid above and below the Fluoresent Orange strip. As much of the aera as possible should be filled with additional strips, in an alternating patteren. The rear window and roof line should be outlined with Reflexite VC312 Daybright Fluorescent Yellow.
The strips of Daybright material used for the chevrons should be a minimum width of 150mm.
The Daybright material used for the rear window and roof line should be a minimum width of 25mm.

The Daybright material should be cut to leave a 6mm gap at the edges of the boot, lights and any fittings.

The word POLICE shall be positioned on either the rear window or the bumper using Reflexite VC312 Daybright Red.

PLEASE NOTE: The Daybright material conforms to shallow curved surfaces, however the material should be cut to allow for complx curves.

Written in VC312
Top